105U/905U-G-ET1 Modbus TCP & OPC Server
The purpose of this document is to provide the reader with an application note for setting up an OPC Server, (KEPServer Enterprise) communicating Modbus TCP with an Elpro 105/905U-G-ET1 gateway.
This application should be read in conjunction with user manuals for details on powering and programming 105/905U-G. The reader would also have a firm understanding of the Modbus TCP protocol and programming the Kelpwares KEPServer OPC Server.
Related Articles
245/U-E Modbus TCP to RTU
The purpose of this document is to show the configuration to setup Modbus TCP to RTU via a back to back pair of 245U-E or 945U-E Ethernet modems.
641M - Modbus Master
This document contains information regarding the configuration and use of the Modbus Master application and using it to poll or scan external Modbus TCP or RTU devices
645M-4 Modbus TCP to RTU serial Conversion.
The following application note demonstrates the configuration of the ELPRO 645M-4 modem using the Modbus TCP to RTU conversion. This will allow serial devices to be connected to the RS232 on the terminal strip which can then be access via the TCPIP ...
245/945U-E Modbus TCP to RTU
The purpose of this document is to show the configuration to setup Modbus TCP to RTU via a back to back pair of 245U-E or 945U-E Ethernet modems.
915U-2 Extended Modbus range
The 915U-2 wireless I/O has always been able to read and write to Modbus slave devices. Some devices however, have addresses outside of our normal range. We have now extended the Modbus address range on the 915U-2 to allow destination registers to ...